Product Directory 
 ·  Grass Seed
 ·  Grass Seed Mixes
 ·  Tank Dam Mix
 ·  Turf Seed
 ·  Wildlife Seed
 ·  Wildlife Seed Mixes
 ·  Spring & Fall Field Seed
 ·  Fall Grazing Mixes
 ·  Wildflowers
 ·  Spring Wildflower Mixes
 ·  Fall Wildflower Mixes
 ·  New Items

- Always plant on fresh disturbed soil
- Establish a firm seedbed
- Don't Plant To Deep
- Develop a root system

One of the most common mistakes when planting grass seed, wildflower seed, etc. is not planting the seed on fresh, disturbed soil. There have been several field plantings that farmers would begin planting and be rained out before finishing. Some would go back into the field and continue planting without disturbing the un-sown part of the field. The part of the field that was not disturbed after the rain never would have the stand that the freshly disturbed seedbed would have. The only exception to this is when the seed is planted with a no-till grass drill.

The second problem that occurs when planting small seed is having a firm seedbed. When most fields are plowed, air pockets are placed in the soil by the plow. During the limited rainfall times, these pockets can allow the seed to germinate and then die when the roots grow into air pockets. With adequate moisture, the "raindrop splash" effect will firm the seedbed where there aren't any air pockets. Through years of planting it has been found that a seedbed can never be too firm. In fact, the firmer the seedbed, the better the stand. Some people will firm the seedbed by rolling it before planting the seed. Others will plant the seed then roll the seedbed. Both ways work in establishing a crop. We feel that rolling the seedbed before planting is better than after, and rolling before and after is best.

The third problem in planting is the depth in which the seed is planted. The old timers had a saying that "seven times the diameter of any seed is the maximum depth that nay seed should be planted." The state of Oklahoma did a study, and found out that up to fifty percent of the wheat seed planted in Oklahoma never came up because it was planted too deep. Considering the size of wheat in comparison to grass and flower seed makes depth of planting critical to success. If a grass seeder with disk openers is used, then make sure that each disk has a depth band on it to insure proper depth placement. If the seed is broadcasted, firming the seedbed by rolling it will insure that the seed is not placed to deep.

The fourth problem in planting seed is the amount of time that the stand needs to establish itself. The Government recommends one full growing season before grazing. This is a wise management tool. Perennials, unlike annuals, need to establish a root system before being grazed. Few stands, if any, have ever died during the winter of the first year if they were allowed to develop their root system. Several stands have been wiped out by grazing or haying the first season. Due to lack of root development.

SETTING SEEDERS
1.  To find the amount of seed to plant for one acre: Take the total bulk pounds of seed and divide by the total acres. (Example: 150 bulk pounds divided by 50 acres = 3 bulk pounds per acre) This would be your planting rate per acre.
2.  A square acre contains 43,560 square feet, or about 70 square yards. NOTE: 70 large steps will be very close.
BROADCAST SEEDERS
1.  Always broadcast seed cross wind. (Example: Wind blowing out of the South should seed East to West).
2.  Broadcast seeders should cover about a ten foot strip, but you need to adjust according to seed weight and wind speed.
3.  Always drive in the same gear, RPM and MPH.
4.  Mark off three, one acre plots, and pour enough seed to plant one acre and start planting.
5.  When you have planted about ¼ of your acre, your should check to see how much seed you have left. At this point, you should close or open the gate on the bottom of the broadcaster. If you are applying too much seed, close the gate. If you are planting too little, open the gate. By the time you have covered your three, one acre plots, you should have your seed rate per acre down very close
DRILLS
1.  Measure distance around the field. Every 1/10th of a mile on your odometer equals 528 feet. Multiply 1/10th x 528 = distance.
2.  The formula would be: distance x width of drill = square feet divided by 43,560 = acres in the first round.
3.  Pour enough seed in drill for the first round. Check drill about every quarter of first round. And open or close as needed. Drill should be very close after three rounds.
4.  If field has several corners, allow about five percent of seed by volume to sow corners. (Example: Distance around field is 9/10th mile. The drill is twelve feet wide. (9 x 528 = 4,752) x 12) = 57,024) divided by 43,560) = 1.3 acres. You would need enough seed in the drill for 1.30 acres or 1 1/3rd acres on your first round.